Kino-flo Tegra 4Bank (TEG-400) Manuel d'utilisateur télécharger pdf (Page 5)

Mounting Procedures

Baby Offset Arm

A 180 degree turn is all that is required to loosen the

mount for orientation.

To adjust the tension on the lock lever, pull handle

away from mount. This disengages the handle from the

screw mechanism and allows the lever to be reoriented.

You can also use a screwdriver to adjust the tension.

Pull back on handle and adjust screw.

Lollipops are interchangeable.

MTP-L Kino 41 Lollipop w/ 3/8” Pin (10mm)

MTP-LB Kino 41 Lollipop w/ Baby Receiver (16mm)

MTP-LBS Kino 41 Lollipop w/ Baby Receiver

Short (16mm)

Mounted on a baby stand Mounted to pipe grid

Note: When hanging in a

studio, loop a safety cord

through the strain-relief ring

provided on the back of the

xture.

The Baby Offset Arm (MTP-B41F) allows xtures to mount on the center of a

stand or can also be under slung from a baby stand to use as an up light.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Kino-flo Tegra 4Bank (TEG-400) Manuel d'utilisateur Page 5